Display, Display assembly, Removing the display assembly – Dell Inspiron 9400 User Manual
Page 20
Back to Contents Page
Display
Dell™ Inspiron™ 9400 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Turn the computer upside down and loosen the two captive screws on the Mini-Card cover.
3.
Disconnect the antenna cables from the Mini-Card, if applicable.
4.
Turn the computer top-side up.
CAUTION:
Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTE:
You must detach the Mini-Card antennas (see
) before you can remove the display assembly. If a Mini-Card is installed, disconnect the
antenna cables from the card. If one is not installed, detach the antenna cables from their secured location.
1
antenna cables