Dell OptiPlex 755 - Manual (Page 16)

Save and exit MEBx and then boot computer to the Microsoft® Windows® operating system.
MEBx Default Settings
The table below lists all the default settings for the Intel® Management Engine BIOS Extension (MEBx).
Intel ME Platform Configuration Default Settings
Intel AMT Configuration Default Settings
*Default setting
**May cause Intel AMT partial unprovision
1 Intel ME Platform State Control is only changed for Management Engine (ME) troubleshooting.
2 In Enterprise mode, DHCP automatically loads the domain name.
Remote FW Update Enabled
Password admin
Intel ME Platform State Control 1
Enabled *
Disabled
Intel ME Firmware Local Update Qualifier
Always Open *
Never Open
Restricted
Intel ME Features Control
Manageability Feature Selection
None
Intel AMT *
ASF
Intel ME Power Control
Intel ME ON in Host Sleep States
Desktop: ON in S0
Desktop: ON in S0, S3
Desktop: ON in S0, S3, S4-5 *
Desktop: ON in S0, ME WoL in S3
Desktop: ON in S0, ME WoL in S3, S4-5
Desktop: ON in S0, S3, S4-5, OFF After Power Loss
Desktop: ON in S0, ME WoL in S3, S4-5, OFF After Power Loss
NOTE: For certain E-Star or low-power configurations, the default setting will be Desktop: ON in SO.
Host Name
TCP/IP
Disable Network Interface? N
DHCP Enabled. Disable? N
Domain Name blank 2
Provision Model
Enterprise. Change to Small Business? N
Setup and Configuration
Current Provisioning Mode Provisioning Mode: PKI
Provisioning Record Displays the provision PSK/PKI record data of the computer.
Provisioning Server
Provisioning Server Address 0.0.0.0
Port Number (0 -65535) 0
TLS PSK
Set PID and PPS ** blank (format ABCD-1234)
Delete PID and PPS **
TLS PKI
Remote Configuration Enable/Disable ** Enabled
Manage Certificate Hashes Four default hashes active
Set FQDN blank
Set PKI DNS Suffix blank
Un-Provision 3
VLAN
VLAN Disabled. Enable? N
VLAN ID (1 -4094) 0 (only if enabled)
SOL/IDE-R
Username & Password
Disabled
Enabled *
Serial Over LAN
Disabled
Enabled *
IDE Redirection
Disabled
Enabled *
Secure Firmware Update
Disabled
Enabled *
Set PRTC blank
Idle Timeout
Timeout Value (0x0 -0xFFFF) 1