Dell Inspiron 17 (7737, Mid 2013) - Manual (Page 41)

Removing the System Board | 41
Removing the System Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before Working Inside
Your Computer" on page 7. After working inside your computer, follow the
instructions in "After Working Inside Your Computer" on page 9. For more
safety best practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You must enter
the Service Tag in System Setup after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location
of the connectors so that you can reconnect them correctly after you replace the
system board.
Prerequisites
1 Remove the battery. See "Removing the Battery" on page 10.
2 Remove the memory modules. See "Removing the Memory Module(s)" on page 13.
3 Remove the optical-drive assembly. See "Removing the Optical Drive" on page 16.
4 Remove the hard-drive assembly. See "Removing the Hard Drive" on page 19.
5 Remove the keyboard. See "Removing the Keyboard" on page 22.
6 Remove the base cover. See "Removing the Base Cover" on page 27.
7 Remove the wireless card. See "Removing the Wireless Card" on page 32.
8 Remove the USB board. See "Removing the USB Board" on page 37.
9 Remove the cooling assembly. See "Removing the Cooling Assembly" on page 34.
10 Remove the coin-cell battery. See "Removing the Coin-Cell Battery" on page 30.
book.book Page 41 Friday, August 16, 2013 4:21 PM