Optical and tape drives, Removing an optical or tape drive – Dell PowerEdge SC 440 User Manual
Page 47
Installing System Components
47
17 (Optional) Test the drive by running the system diagnostics. See "Running the System Diagnostics" on
Optical and Tape Drives
In the upper 5.25-inch drive bay, you can install only an optical drive. In the lower 5.25-inch drive bay,
you can install either an optical or a tape backup unit.
Removing an Optical or Tape Drive
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 41.
3 Remove the front drive bezel. See "Removing the Front Drive Bezel" on page 42.
4 Disconnect the power and data cables from the back of the drive. See Figure 3-7.
5 Slide the lever on the sliding plate in the direction of the arrow to release the shoulder screw.
6 Slide the drive out to remove it from the drive bay.
book.book Page 47 Tuesday, August 25, 2009 1:14 PM