Installing the system battery – Dell PowerEdge SC 440 User Manual
Page 68
68
Installing System Components
5 Press the tab on the battery socket to release the battery, then lift the battery out of the socket. See
Figure 3-18.
Removing and Installing the System Battery
Installing the System Battery
1 Install the new battery with the "+" facing up, and press down until it snaps into place. See
2 Close the system. See "Closing the System" on page 41.
3 Reconnect the system to the electrical outlet and turn on the system and attached peripherals.
4 Enter the System Setup program to confirm that the battery operates properly. See "Using the System
5 From the main screen, select System Time to enter the correct time and date.
6 Re-enter any system configuration information that is no longer displayed on the System Setup
screens, and then exit the System Setup program.
7 To test the newly installed battery, see "Troubleshooting the System Battery" on page 85.
8 After an hour, reconnect the system to a power source and turn it on.
9 Enter the System Setup program. If the time and date are still incorrect, see "Getting Help" on
10 Properly dispose of the old battery. For more information, see your Product Information Guide.
1
battery socket
2
system battery
3
tab
2
3
1
book.book Page 68 Tuesday, August 25, 2009 1:14 PM