Dell XPS 410 (Mid 2007) - Manual (Page 79)

Removing and Installing Parts
79
NOTICE:
Before touching anything inside your computer, ground yourself by touching an unpainted metal surface,
such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface to
dissipate any static electricity that could harm internal components.
1 Follow the procedures in "Before You Begin" on page 77.
2 If you have installed a security cable, remove it from the security cable slot.
NOTICE:
Ensure that sufficient space exists to support the removed cover—at least 30 cm (1 ft) of desk top space.
NOTICE:
Ensure that you are working on a level, protected surface to avoid scratching either the computer or the
surface on which it is resting.
3 Lay your computer on its side with the computer cover facing up.
4 Pull back the cover release latch on the top panel.
5 Locate the three hinge tabs on the bottom edge of the computer.
6 Grip the sides of the computer cover and pivot the cover up.
7 Lift the cover away and set it aside in a secure location.
1 cover release latch 2 computer cover 3 hinge tabs (3)
2
1
3