Dell XPS 410 (Mid 2007) - Manual (Page 88)

88
Removing and Installing Parts
3 Push the two release tabs on the card retention door from the inside to pivot the door open. Because
the door is hinged, it will remain in the open position.
4 If your computer includes a card retention mechanism to secure the x16 card, press the release tab
downward gently and then pivot the mechanism upward to access the card slots.
5 If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue
with step 7.
6 If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. Grasp the card by its top corners, and ease it
out of its connector.
7 Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making
internal connections, or otherwise customizing it for your computer.
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To
guard against electrical shock, be sure to unplug your computer from its electrical outlet before installing any
cards.
8 Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
1 release tab 2 card retention mechanism 3 card retention door
3 1
2