Dell PowerVault DL2200 CommVault - Manual (Page 104)

104
Installing System Components
CAUTION:
Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper thermal
conditions.
5 Using a #2 Phillips screwdriver, loosen one of the heat-sink retention
screws. See Figure 3-18.
6 Wait 30 seconds for the heat sink to loosen from the processor.
7 Loosen the other three heat-sink retention screws.
8 Gently lift the heat sink off of the processor and set the heat sink aside
with thermal grease side facing up.
CAUTION:
The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
9 Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position. Rotate the lever 90 degrees
upward until the processor is released from the socket. See Figure 3-19.
book.book Page 104 Wednesday, May 12, 2010 9:26 PM