Installing the power supply – Dell Precision T1600 (Early 2011) User Manual
Page 49
Advertising
9.
Lift the power supply out of the computer.
Related Links
Installing The Power Supply
1.
Place the power supply in the chassis and slide towards the back of the system to
secure it.
2.
Use a Phillips screwdriver to tighten the screws securing the power supply to the
back of the computer.
3.
Connect the 4-pin power cable to the system board.
4.
Connect the 24-pin power cable to the system board.
5.
Thread the power cables into the chassis clips.
6.
Connect the power cables connected to the hard drives(s) and optical drive(s).
7.
Install the
8.
Follow the procedures in
After Working Inside Your Computer
Related Links
49
Advertising