Dell Precision T1600 (Early 2011) - Manual (Page 52)

9. Carefully tilt the system board to 45–degrees, and then lift the system board out of
the computer.
Related Links
Installing the System Board
Installing The System Board
1. Align the system board to the port connectors on the rear of the chassis and place
the system board in the chassis.
2. Tighten the screws securing the system board to the chassis.
3. Connect the cables to the system board.
4. Install the Heat sink and Processor .
5. Install the Expansion Card .
6. Install the Front Bezel .
7. Install the Cover .
8. Follow the procedures in After Working Inside Your Computer .
Related Links
Removing the System Board
52