Dell Dimension 4400 - Manual (Page 44)

IDE Configuration Submenu
Option Function
Serial Port A Configures the serial port. Set this option to Auto (default), Enabled, or Disabled. Depending on the port setting, you can set the
following additional options:
l Base I/O Address
If the port is set to Enabled, available I/O addresses are 3F8, 3E8, 2F8, and 2E8.
l Interrupt
If the port is set to Enabled, available interrupts are IRQ3 and IRQ4.
Parallel Port Configures the parallel port. Set this option to Auto (default), Enabled, or Disabled. Depending on the port setting, you can set the
following additional options:
l Mode
If the port is set to Auto or Enabled, available modes are Output Only, Bi-Directional (default), ECP, and EPP.
See the device manufacturer's documentation for information on which mode to use before changing this setting.
l Base I/O Address
If the port is set to Enabled, available I/O addresses are 378 (default), 278, and 228.
l Interrupt
If the port is set to Enabled, available interrupts are 7 and 5.
Onboard Audio
Device Sets the integrated audio controller to either Enabled (default) or Disabled.
Legacy USB
Support Set to Enabled (default) to allow support for legacy USB. Set to Disabled if legacy USB support is not desired.