Dell OptiPlex SX260 - Manual (Page 43)

6. Replace the computer cover.
7. Reattach the stand (if used).
8. Replace the cable cover (if used).
9. Connect your computer to the adapter cable and devices to electrical outlets, and turn them on.
After you replace the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer start-
up:
ALERT! Cover was previously removed.
10. Reset the chassis intrusion detector by changing the Chassis Intrusion option to Enabled or Enabled-Silent.
11. Enter system setup and restore the settings you recorded in step 1.
12. Properly dispose of the old battery .
Back to Contents Page
1 location of the battery
connector
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis
intrusion detector.