Dell Latitude E6410 - Manual (Page 32)

Back to Removing and Replacing Parts
I/O port card
Dell™ Latitude™ E6410/E6410 ATG Service Manual
Removing the I/O port card
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the ATG port cover (applicable on E6410 ATG computer only).
3. Remove the battery .
4. Remove the optical drive .
5. Remove the hard drive .
6. Remove the hinge covers .
7. Remove the access panel .
8. Remove the coin-cell battery .
9. Remove the Heat Sink and Processor fan .
10. Remove the LED cover .
11. Remove the keyboard .
12. Remove the display assembly .
13. Remove the palm rest .
14. Remove the modem .
15. Remove the modem connector .
16. Remove the ExpressCard cage .
17. Remove the palm rest .
18. Remove the system board .
19. Remove the screw that secures the I/O port card to the computer.
20. Lift the left edge of the I/O port card and remove the I/O port card from the computer.
Replacing the I/O port card
To replace the I/O port card, perform the above steps in reverse order.
Back to Removing and Replacing Parts
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.