CDA HVN 32 - Manual (Page 13)

13
Program for Automatic Switching OFF of One Cooking Zone
This function permits to set a timer from
1
to
99
minutes for
automatic turning OFF of one cooking zone only.
Note: It is not possible to set this program for both the cooking
zones.
With the touch control switched ON:
– Press the timer keys
or ; a beep sounds and the timer
display shows "
00
". The displays of the cooking zones show
" " (timer).
– Within 10 seconds, select the cooking zone to be programmed
by using the cooking zone keys or ; a beep sounds and
the led next to the heater display start blinking.
– Set the disired power level by using the cooking zone keys
or ; the led next to the heater display is stably lit (not
blinking).
– Within 10 seconds, set the timer by using the timer keys or
to increase or reduce the value (when touching the keys,
the led next to the heater display is blinking). If the selected
time is "
00
", the timer is switched off automatically after
10 seconds.
– The countdown starts 10 seconds after the last selection. The
time can be changed at any time by using the timer keys; the
countdown stops and then the timer changes the stop time.
Now the program for automatic switching off is complete.
At the end of the countdown the cooking zone will switch
off automatically, an acoustic signal (beep) will sound (for
one minute only), "
00
" will flash on the timer display
and the led next to the heater display will blink.
Press any button of the touch control to reset the timer.
Note: The program for automatic switch off can be cancelled at
any time by resetting the timer to "
00
").
OR
OR
OR