Dell POWEREDGE M1000E - Manual (Page 108)

94 Fabric OS Troubleshooting and Diagnostics Guide
53-1001769-01
Port information
10
Port information
Use the following instructions to view information about ports and to help diagnose if your switch is
experiencing port problems.
Viewing the status of a port
1. Connect to the switch and log in as admin.
2. Enter the portShow [slot/] port command, specifying the number that corresponds to the port
you are troubleshooting. In this example, the status of port 10 is shown:
switch:admin> portshow 10
portName:
portHealth: HEALTHY
Authentication: None
portDisableReason: None
portCFlags: 0x1
portFlags: 0x20b03 PRESENT ACTIVE F_PORT G_PORT U_PORT LOGICAL_ONLINE LOGIN
NOELP ACCEPT FLOGI
portType: 18.0
POD Port: Port is licensed
portState: 1Online
portPhys: 6In_Sync
portScn: 32F_Port
port generation number: 14
portId: 020a00
portIfId: 4302000b
portWwn: 20:0a:00:05:1e:41:4a:a5
portWwn of device(s) connected:
21:00:00:e0:8b:05:e0:b1
Distance: normal
portSpeed: N2Gbps
LE domain: 0
FC Fastwrite: OFF
Interrupts: 0 Link_failure: 0 Frjt: 0
Unknown: 0 Loss_of_sync: 3 Fbsy: 0
Lli: 18 Loss_of_sig: 6
Proc_rqrd: 161 Protocol_err: 0
Timed_out: 0 Invalid_word: 563851
Rx_flushed: 0 Invalid_crc: 0
Tx_unavail: 0 Delim_err: 0
Free_buffer: 0 Address_err: 0
Overrun: 0 Lr_in: 3
Suspended: 0 Lr_out: 0
Parity_err: 0 Ols_in: 0
2_parity_err: 0 Ols_out: 3
CMI_bus_err: 0
Port part of other ADs: No
See the Fabric OS Command Reference for additional portShow command information, such as
the syntax for slot or port numbering, displaying IP interfaces on a GbE port, or displaying FCIP
tunnel connection or configuration information.