Dell Vostro 360 (Late 2011) - Manual (Page 46)

7. Disengage the cable from the chassis clips and remove the power-switch
assembly.
Installing The Power-Switch Assembly
1. Place the power-switch assembly on the chassis.
2. Connect the power-switch assembly cable to the system board and thread the
cables into the chassis clips.
3. Tighten the screw that secures the power-switch assembly to the chassis.
4. Install the rear I/O cover .
5. Install the rear stand .
6. Install the rear cover .
7. Follow the procedures in After Working Inside Your Computer .
46