Dell XPS M1330 (M1330, Mid 2007) - Manual (Page 119)

Troubleshooting
119
Manually Reinstalling Drivers
NOTE:
If your computer has a Consumer IR port and you are reinstalling a
Consumer IR driver, you must first enable the Consumer IR port in the system setup
program (see "Dell Technical Support Policy (U.S. Only)" on page 173) before
continuing with the driver installation (see "Reinstalling Drivers and Utilities" on
page 117). For information about components installed on your computer, see
"Determining Your Computer’s Configuration" on page 19.
1 After extracting the driver files to your hard drive, as described in the
previous section, click Start , and then right-click Computer.
2 Click Properties, and then click Device Manager.
3 Double-click the type of device for which you are installing the driver (for
example, Modems or Infrared devices).
4 Double-click the name of the device for which you are installing the driver.
5 Click Driver tab, and then click Update Driver.
6 Click Install from a list or specific location (Advanced), and then click Next.
7 Click Browse and browse to the location to which you previously copied
the driver files.
8 When the name of the appropriate driver appears, click Next.
9 Click Finish, and then restart your computer.
Troubleshooting Software and Hardware
Problems in the Windows Vista
®
Operating
System
If a device is either not detected during the operating system setup or is
detected but incorrectly configured, use Windows Vista Help and Support to
resolve the incompatibility.
NOTE:
Windows Vista
®
is a new operating system, so drivers or applications that
support certain devices may not yet be available. Check with your hardware
manufacturer for information on Windows Vista support for your device.
book.book Page 119 Tuesday, October 7, 2008 6:00 PM