Dell POWEREDGE M1000E - Manual (Page 18)

16 System Firmware Version 4.1.0.6
Issues Resolved
The following issues from previous releases have been corrected in this release. The issues listed here may have been discovered
on any of the switches listed on the title page.
Summary User Impact Workaround
SSH crash - memPartAlloc: block too big Reduced switch functionality. Memory allocation issue is corrected and
checked for memory leaks
PC M8024 switch reset out-of-band
address to none when switchports were
changed Inability to access switch via OOB
port. The out-of-band address is maintained
over switchport changes.
Web page shows IP address as '0.0.0.0'
for '1.1.1.1' routing interface. Operator confusion over switch
operations The web page output has been corrected.
Read-Only Web page is populating all
configured IP and IPv6 ACL names when
we select the ACL Name. Operator confusion regarding web
page operations. The web page has been corrected to only
populate the selected entry.
FAN LED graphic on web page needs to
glow in RED when FANs are not
operational (stopped). Inability to determine switch
status. Web page has been corrected
Incorrect command is being displayed in
running-config, when disabled the boot
host dhcp Operator confusion regarding web
page operations. The running config now shows the correct
configuration
DUT crashes while configuring max
dynamic vlans. Network outage possible. The PowerConnect does not crash when
using maximum dynamic VLANs
Manager of the stack is changing when
trying to learn maximum number of
VLANs using GVRP. Operator confusion regarding
switch operations. The stack manager does not change during
learning with GVRP
Switch prompts to save config data when
no changes have been made Operator confusion regarding
switch operation. The switch no longer prompts to save
config data if no changes have been made
Crash while RFC3918 Group Capacity
test is running Network outage possible. The PowerConnect switch runs the
RFC3918 test without crashing
'no' version of 'key' command is not
implemented Operator frustration with switch
management. The no key command is implemented to
return the key configuration to the default.
Password is not accepting quotation ( " )
character Operator confusion regarding
switch configuration. Passwords can be enclosed in quotes
(contain embedded blanks). A password
may not contain a quote. The accepted
character set and length is documented in
the CLI reference manual.
Incorrect warning message displayed
while executing the command "boot
system <unit> image1" Operator confusion regarding
switch operation. The error message has been corrected to
indicate that the unit selected for reboot
does not exist.
IPV6 command displays wrong output Operator confusion regarding
switch operation. The IPv6 output has been corrected to
remove the duplicate display lines in show
ipv6 help.
LLDP-MED log messages showing 5 sec
difference in entry age out information Operator confusion regarding
switch operation. The LLDP timer has been updated to
account for processing skew.
Dhcpv6 web issues Operator confusion regarding
switch configuration. The acceptable character sets are
documented in the CLI Reference guide.
LLDP MED application should not allow
configuration of location and inventory
transmit TLV's as underlying application
not present Operator confusion regarding
switch configuration. Location and inventory TLVs cannot be
enabled for transmission in LLDP MED.