Dell PowerEdge C6220 II - Manual (Page 59)

59
FILE LOCATION: D:\Projects\User
Guide\Server\Dell\C6220II\BMC\C6220II_BMC_HOM_section1.fm
Get Peripheral Device Controller Reset Status Command Byte Order and Field Format
Table 1-48. Get Peripheral Device Controller Reset Status Command (NetFn: 0x30H)
Command NetFn CMD Privelege
Get Peripheral Device Controller Reset
Status
0x30h 4Bh Admin
Byte Data Field
Request Data 1 Controller to query for reset status
• [7:1] - Reserved
• [0] - Expander controller
NOTE: When the command is issued only one bit
can be set to 1b. If you reset multiple peripheral
devices and would like to know the reset status, you
have to issue the command multiple times.
Response Data 1 Completion code
00h: Success
2 Communication protocol version
Set as 11h for this specification
3 Reset status
• 00h: Reset completed
• 01h: Reset in progress
• 02h: Reset not currently initiated (i.e. Since last
AC cycle or BMC reset, no reset request has been
made for this peripheral device)
• 03h: Controller reset is being requested (i.e.
After Reset Peripheral Device Controller
command is issued)
• 04h: Controller reset timeout (Waited 60
seconds, but a reset did not occur)