Dell UltraSharp 34 Curved Monitor - Manual (Page 31)

Setting Up the Monitor | 31
B) Monitor fails to show any content (blank screen)
1 Use the and buttons to highlight DP or mDP.
2 Press and hold the button for approximately 8 seconds.
3 The DisplayPort configuration message will appear.
4 Use the button to enable DP1.2 or button to exit without making any
changes.
Repeat the above steps to change the setting back to DP1.1a if necessary.
CAUTION: The graphics are used for the purpose of illustration only. Appearance
of the computer may vary.