Dell Precision 220 - Manual (Page 40)

Microprocessor/Heat Sink Assembly
To replace a microprocessor, perform the following steps.
1. Remove the computer cover .
2. Remove the airflow shroud.
Squeeze in on the two pairs of tabs on the shroud and lift it away.
3. Remove the existing microprocessor from its connector.
Press outward on the guide bracket tabs to release them from the processor/heat sink assembly. Then pull the processor/heat sink assembly
out of its connector (see
Figure 29 ). You must use up to 15 lb of force to disengage the processor from the connector.
Figure 29. Microprocessor Removal
To install a replacement microprocessor and heat sink assembly, perform the following steps:
Figure 30. Microprocessor Replacement
NOTE: Before disconnecting a peripheral from the system or removing a component from the system board, disconnect the system
power cord and verify that the standby power LED on the system board is off. For the location of this LED, see
Figure 25 .
CAUTION: Before you remove the computer cover, see " Precautionary Measures "
1 Airflow shroud
2 Thumbscrews (2)
3 Processor/heat sink assembly
4 Guide bracket
5 Second processor (terminator card if a second
processor is not present)