Display assembly, Removing the display assembly – Dell Inspiron 6400 User Manual
Page 17
Back to Contents Page
Display Assembly
Dell™ Inspiron™ 6400/E1505 Service Manual
Replacing the Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the hinge cover (see
Removing the Hinge Cover
).
3.
Remove the keyboard (see
Keyboard
).
4.
Remove the two M2.5 x 8-mm screws from the bottom of the display.
5.
Remove the two screw covers from the back of the computer; then, remove the two M2.5 x 8-mm screws from the back of the computer.
6.
Remove the two M2.5 x 5-mm screws from the top side of the computer.
7.
Disconnect the antenna cables from the Mini-Card.
8.
Loosen the captive grounding-wire screw.
9.
Disconnect the display cable, using the pull-tab.
10.
Dislodge the display cable from the display cable channel.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
1
M2.5 x 8-mm screws (2)
1
M2.5 x 8-mm screws (2)