Replacing the display bezel – Dell Inspiron 6400 User Manual
Page 19
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the display assembly (see
).
3.
Remove the six rubber display bumpers.
4.
Remove the six M2.5 x 4.2-mm screws around the display bezel.
5.
Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge of the
display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear the
tab on the side of the lower-right corner. Continue this motion until you have cleared all sides of the display bezel.
Replacing the Display Bezel
1.
Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the display panel.
2.
Replace the six M2.5 x 4.2-mm screws around the display bezel.
3.
Replace the six rubber display bumpers around the display bezel.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
Before Working Inside Your Computer
) before you
begin working inside the computer.
1 M2.5 x 4.2-mm screws(6)
2 rubber display bumpers (6)
3 display bezel
NOTICE:
Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.
1
display bezel
2
display panel