Dell Inspiron 6400 User Manual
Page 29
Back to Contents Page
Memory Module(s)
Dell™ Inspiron™ 6400/E1505 Service Manual
Replacing the Memory Module(s)
Removing the Memory Module(s)
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Turn the computer upside-down, loosen the two captive screws on the memory module cover, and remove the cover.
3.
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4.
Remove the module from the connector at a 45-degree angle.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
Before Working Inside Your Computer
) before you
begin working inside the computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
NOTE:
To get maximum performance/dual-channel memory bandwidth capability, both memory module connectors must contain memory modules and
the modules must be of the same size and configuration.
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the securing clips that secure the memory module.
NOTICE:
Handle memory modules by their edges, and do not touch the components on a module.
1
memory module
2
securing clips (2)