Removing the system board, Prerequisites, Procedure – Dell Inspiron 17 (5748, Mid 2013) User Manual
Page 65
Removing the System Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
NOTE: Your computer’s Service Tag is stored in the system board. You
must enter the Service Tag in the system setup after you replace the
system board.
NOTE: Replacing the system board removes any changes you have
made to the BIOS using System Setup. You must make the desired
changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the
location of the connectors so that you can reconnect them correctly
after you replace the system board.
Prerequisites
1
Remove the
.
2 Remove the
.
3 Remove the
.
4 Follow the procedure from step 1 to step 3 in removing the
.
5 Follow the procedure from step 1 to step 2 in removing the
6 Remove the
.
7
Remove the
8 Remove the
9 Remove the
.
10 Remove the
.
Procedure
1
Close the display and turn the computer over.
2 Remove the antenna cables from the routing guides on the computer
base.
3 Slide the antenna cables through the slot on the computer base.
65