Wireless mini-card, Removing the mini-card, 6 disconnect the antenna cables from the mini-card – Dell Alienware M17x R3 (Early 2011) User Manual

Page 59

Advertising
background image

Wireless Mini-Card

59

14

Wireless Mini-Card

WARNING:

Before working inside your computer, read the safety information

that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.

CAUTION:

To avoid electrostatic discharge, ground yourself by using a wrist

grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).

CAUTION:

Only a certified service technician should perform repairs on your

computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.

CAUTION:

To help prevent damage to the system board, remove the main battery

(see "Removing the Battery Pack" on page 13) before working inside the computer.

NOTE:

Dell or Alienware does not guarantee compatibility or provide support for

Mini-Cards from sources other than Dell or Alienware.

If you ordered a wireless Mini-Card with your computer, the card is already

installed.
Your computer supports one half Mini-Card slot for WLAN.

NOTE:

Depending on the configuration of the computer when it was sold, the

Mini-Card slot may or may not have a Mini-Card installed.

Removing the Mini-Card

1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery pack (see "Removing the Battery Pack" on page 13).
3 Remove the compartment door (see "Removing the Compartment Door"

on page 15).

4 Remove the center control cover (see "Removing the Center Control

Cover" on page 49).

5 Remove the keyboard (see "Removing the Keyboard" on page 55).
6 Disconnect the antenna cables from the Mini-Card.

Advertising