Dell Dimension 9150/XPS 400 - Manual (Page 101)

Removing and Installing Parts
101
Installing a Media Card Reader
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer chassis.
1 Follow the procedures in "Before You Begin" on page 63.
2 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
3 Remove the computer cover (see page 68).
4 Remove the drive panel (see page 89).
5 Remove the Media Card Reader from its packaging and ensure that all four screws are
included.
6 Gently slide the drive into place until you feel a click or feel the drive securely installed.
Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
Media Card
Reader
screws (4)