Dell Studio Slim D540S (Late 2008) - Manual (Page 17)

6. Press the two spring clamps and slide out the Media Card Reader along with the FlexBay drive cage from the FlexBay slot.
7. Remove the two screws holding the Media Card Reader in the FlexBay drive cage.
8. Lift the Media Card Reader to separate it from the FlexBay drive cage.
9. If you are not reinstalling the Media Card Reader:
a. Replace the optical drive (see Replacing the Optical Drive )
b. Reinstall the FlexBay drive insert.
c. Replace the front panel (see Replacing the Front Panel ').
d. Replace the computer cover (see Replacing the Computer Cover ).
10. If you are installing a new Media Card Reader, remove the Media Card Reader from its packaging.
11. Remove the FlexBay drive insert (see Replacing the FlexBay/FlexDock Drive Insert ).
12. Press the two spring clamps and slide out the FlexBay drive cage from the front of the system.
13. Place the Media Card Reader in the FlexBay drive cage and slide it towards the cage notch to align the cage notch with the notch holes in the Media
Card Reader.
14. Align the two screw holes on the Media Card Reader with the FlexBay drive cage.
15. Tighten the two screws to secure the Media Card Reader in the FlexBay drive cage.
16. Slide the FlexBay drive cage along with the Media Card Reader in the FlexBay slot till it snaps in place.
17. Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector (F_USB5) on the system board (see System
Board Components ).
18. Replace the optical drive (see Replacing the Optical Drive ).
19. Replace the front panel (see Replacing the Front Panel ).
20. Replace the computer cover (see Replacing the Computer Cover ).
21. Connect your computer and devices to electrical outlets, and then turn them on.
Replacing the FlexDock
1. Follow the procedures in Before You Begin .
2. Remove the computer cover (see Replacing the Computer Cover ).
1 FlexBay drive cage 2 spring clamps (2)
3 cage notch (2) 4 Media Card Reader
5 screws (2)
NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected.