Dell Studio Slim D540S (Late 2008) - Manual (Page 18)

3. Remove the front panel (see Replacing the Front Panel ).
4. Remove the optical drive (see Replacing the Optical Drive ).
5. Disconnect the FlexDock USB cable from the back of the FlexDock and from the internal USB connector (F_USB1) on the system board (see System Board
Components ).
6. Press the two spring clamps and slide out the FlexDock along with the FlexDock drive cage from the FlexDock slot.
7. Remove the two screws holding the FlexDock in the FlexDock drive cage.
8. Lift the FlexDock to separate it from the FlexDock drive cage.
9. If you are not reinstalling the FlexDock:
a. Replace the optical drive (see Replacing the Optical Drive )
b. Reinstall the FlexBay/FlexDock drive insert.
c. Replace the front panel (see Replacing the Front Panel ').
d. Replace the computer cover (see Replacing the Computer Cover ).
10. If you are installing a new FlexDock, remove the FlexDock from its packaging.
11. Remove the FlexBay/FlexDock drive insert (see Replacing the FlexBay/FlexDock Drive Insert ).
12. Press the two spring clamps and slide out the FlexDock drive cage from the front of the system.
13. Place the FlexDock in the FlexDock drive cage and slide it towards the cage notch to align the cage notch with the notch holes in the FlexDock.
1 FlexDock cable 2 spring clamp 3 FlexDock
1 FlexDock drive cage 2 spring clamps (2)
3 cage notch (2) 4 FlexDock
5 screws (2)