Dell Studio Slim D540S (Late 2008) - Manual (Page 19)

14. Align the two screw holes on the FlexDock with the FlexDock drive cage.
15. Replace the two screws to secure the FlexDock in the FlexDock drive cage.
16. Slide the FlexDock drive cage along with the FlexDock in the FlexDock slot till it snaps in place.
17. Connect the FlexDock USB cable to the back of the FlexDock and to the internal USB connector (F_USB1) on the system board (see System Board
Components ).
18. Replace the optical drive (see Replacing the Optical Drive ).
19. Replace the front panel (see Replacing the Front Panel ).
20. Replace the computer cover (see Replacing the Computer Cover ).
21. Connect your computer and devices to electrical outlets, and then turn them on.
Removing the FlexBay/FlexDock Break-Away Metal Plate
Align the tip of a Phillips screwdriver with the slot on the break-away metal plate and rotate the screwdriver outwards to break and remove the metal plate.
Replacing the FlexBay/FlexDock Drive Insert
1. Remove the front panel (see Replacing the Front Panel ).
NOTE: Ensure that the FlexDock is installed before the FlexDock cable is connected.
1 front panel 2 FlexBay drive insert lever 3 FlexBay drive insert