Opening the computer cover – Dell OptiPlex GX270 User Manual
Page 136
Back to Contents Page
Opening the Computer Cover
Dell™ OptiPlex™ GX270 Systems User's Guide
1.
Shut down the computer through the Start menu.
2.
Ensure that your computer and attached devices are turned off. If your computer and attached devices did not automatically turn off when you shut
down your computer, turn them off now.
3.
Disconnect any telephone or telecommunication lines from the computer.
4.
Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.
5.
Lay the computer on its side as shown in the illustration.
6.
Open the cover:
a.
Facing the back of the computer, press the release button on the right side of the computer with one hand while pulling up on the top of the
cover with the other hand.
b.
Press the release button on the left side of the computer with one hand while pulling up on the top of the cover with the other hand.
c.
Hold the bottom of the computer with one hand, and then pull open the cover with the other hand.
Back to Contents Page
CAUTION:
Before you begin any of the procedures in this section, follow the steps in "
Safety Instructions
."
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE:
Ensure that there is sufficient space to support the open cover—at least 30 cm (1 ft) of desk top space.
1 release buttons (2)
2 security cable slot
3 padlock ring