Optical drive, Removing an optical drive – Dell OptiPlex 745c (Early 2007) User Manual
Page 68
4.
Attach the power and data cables to the floppy drive.
5.
Replace the computer cover (see
Replacing the Computer Cover
).
6.
Enter system setup (see
Entering System Setup
), and use the Diskette Drive option to enable your new floppy drive.
7.
Verify that your computer works correctly by running the Dell Diagnostics (see
Dell Diagnostics
).
Optical Drive
Removing an Optical Drive
1.
Follow the procedures in
Before You Begin
.
2.
Disconnect the power and data cables from the back of the drive.
3.
Grasp the sliding plate lever and slide it towards the top of the computer until the drive panel snaps open; while holding the lever in place, slide the
drive out of the computer.
1
floppy drive
2
shoulder screws (4)
3
shoulder screw slots (2)
1
power cable
2
data cable
3
floppy-drive connector (DSKT)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before replacing the cover.