Flashing the bios – Dell Latitude C400 User Manual
Page 30
Flashing the BIOS
Dell™ Latitude™ C400 Service Manual
Perform the following steps to update the BIOS:
1. Make sure that the AC adapter is plugged in and that the main battery is installed properly.
2. Turn on the computer. The following error message appears:
System hardware failures: #0010
Strike the F1 key to shutdown
3. Instead of pressing <F1>, insert the Flash BIOS update floppy disk or CD into the appropriate drive and press <F6>,
and then press <F4>. The computer displays the following message on the screen:
Failure override
Processor update failure. Reload current BIOS
Strike the F1 key to continue, F2 to run the setup utility.
4. Press <F1>. The computer continues to boot and updates the new BIOS.
5. Press <F2> to enter the system setup program and reset the boot sequence with the appropriate drive, if required.
6. Press <ESC> to exit the system setup program.
7. Remove the Flash BIOS update floppy disk or CD from the drive and restart the computer.