Dell Inspiron 600m - Manual (Page 38)

38
Using Batteries and Module Bay Devices
www
.dell.com | support.dell.com
2 Pull the device by the latch release to remove the device from the module bay.
3 Insert the new device into the bay, push the device until you feel a click, and push the device
latch release in so that it is flush with the computer.
Removing and Installing Devices While the
Computer Is Running
CAUTION:
Before you begin any of the procedures in this section, read the safety instructions in your
Product Information Guide.
NOTE:
If the device screw is not installed, you can remove and install devices while the computer is
running and connected to a docking device (docked).
1 Double-click the Safely Remove Hardware icon on the taskbar.
2 Click Stop and wait for the operating system to confirm that the device has stopped.
3 Click the device you want to eject.
NOTICE:
To prevent damage to devices, place them in a safe, dry place when they are not installed in
the computer. Avoid pressing down on them or placing heavy objects on top of them.
4 Press the device latch release so that the latch release pops out.