Dell Inspiron 600m - Manual (Page 82)

82
Adding and Replacing Parts
www
.dell.com | support.dell.com
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the inner metal
tabs that secure the memory module.
6 If you are replacing a memory module, remove the existing module.
NOTICE:
Handle memory modules by their edges, and do not touch the components on a module.
a Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector until the module pops up.
b Remove the module from the connector.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the
connector labeled "SLOT 1" before you install a module in the other connector.
7 Ground yourself and install the new memory module:
NOTE:
If the memory module is not installed properly, the computer does not boot. No error message
indicates this failure.
a Align the notch in the module with the slot in the center of the connector.
NOTICE:
Only hold the module by the shorter, notched ends. Do not push on the longer, outer edge.
b Holding the shorter, notched ends of the module, slide the edge of the module firmly into
the connector, and rotate the module down until you feel a click. If you do not feel the
click, remove the module and reinstall it.
8 Replace the cover and screw.
NOTICE:
If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the
cover to close may damage your computer.