Replacing the optical-drive connector board, Procedure, Post-requisites – Dell Inspiron 15 (3542, Early 2014) User Manual
Page 58
Replacing the Optical-Drive
Connector Board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1
Slide the optical-drive connector board into the system-board
connector.
2 Replace the screw that secures the optical-drive connector board to the
computer base.
3 Route the antenna cables on the optical-drive connector board and slide
the cables into the slot on the computer base.
4 Close the display and turn the computer over.
5 Route the antenna cables through the routing guide on the computer
base.
6 Connect the antenna cables to the wireless card. See “Replacing the
”.
Post-requisites
1
Follow the procedure from step 3 to step 9 in “Replacing the
”.
2 Replace the
.
3 Follow the procedure from step 4 to step 5 in “Replacing the
4 Follow the procedure from step 4 to step 6 in “Replacing the
”.
5 Replace the
6 Replace the
.
58