Replacing the hall-sensor board, 5 adhere the sponge pad to the palm-rest assembly – Dell XPS 14Z (L412Z, Late 2011) User Manual
Page 37
Hall-Sensor Board
37
Replacing the Hall-Sensor Board
1 Follow the instructions in "Before You Begin" on page 7.
2 Align the screw hole on the hall-sensor board with the screw hole on the
palm-rest assembly.
3 Replace the screw that secures the hall-sensor board to the palm-rest
assembly.
4 Slide the hall-sensor-board cable into the system-board connector and
press down on the connector latch to secure the cable.
5 Adhere the sponge pad to the palm-rest assembly.
6 Replace the hard drive (see "Replacing the Hard Drive" on page 28).
7 Replace the battery (see "Replacing the Battery" on page 16).
8 Replace the base cover (see "Replacing the Base Cover" on page 12).
CAUTION:
Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1
screw
2
system-board connector
1
2
book.book Page 37 Thursday, May 3, 2012 3:09 PM