Display assembly and display latch, Display assembly – Dell Latitude D500 User Manual
Page 10
Back to Contents Page
Display Assembly and Display Latch
Dell™ Latitude™ D500 Service Manual
Display Assembly
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
keyboard
.
3.
Open the display assembly approximately 180 degrees, and support the display assembly so that it does not open past this position.
4.
Loosen the captive screw that secures the display cable to the system board, and release the cable from the four cable-routing clips.
5.
Pull up on the pull-tab that is attached to the display cable connector to remove the connector from the system board.
6.
Remove the three M2.5 x 6-mm screws.
7.
Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
You must remove the display assembly before you remove the palm rest.
1 M2.5 x 6-mm screws (3)
2 display cable connector
3 display
4 computer base
5 pull-tab
6 system board connector
7 captive screw
8 cable-routing clips (4)