Dell Latitude D500 - Manual (Page 24)

Back to Contents Page
Palm Rest
Dell™ Latitude™ D500 Service Manual
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the keyboard .
3. Remove the display assembly .
4. Remove the three M2 x 3-mm screws labeled "circle P" from the top of the palm rest.
5. Disconnect the touch pad connector from the system board.
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest; the display hinges pass through the back of the palm rest.
1 M2 x 3-mm screws (3)
2 top of the palm rest