System board, Removing the system board – Dell Latitude D500 User Manual
Page 31
Back to Contents Page
System Board
Dell™ Latitude™ D500 Service Manual
Removing the System Board
The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the computer. The replacement kit for the
system board includes a CD that provides a utility for transferring the Service Tag to the replacement system board.
1.
Follow the instructions in "
Preparing to Work Inside the Computer
."
2.
Remove the
keyboard
.
3.
Remove the
display assembly
.
4.
Remove the
palm rest
.
5.
Remove the
microprocessor thermal-cooling assembly
.
6.
Remove the
microprocessor
.
7.
Remove the one M2.5 x 8-mm screw and one M2.5 x 4-mm screw labeled "circle B."
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
1
M2.5 x 4-mm screw
2
M2.5 x 8-mm screw
3
system board