Installing the optional 1x2 flex bay bracket, T (see figure 1-8 for latc – Dell PowerEdge 2900 User Manual
Page 21
Tower-to-Rack Conversion Guide
19
Installing the Optional 1x2 Flex Bay Bracket
NOTE:
The rack front panel is keyed so that the 1x2 flex bay bracket installs in the opposite orientation as the
tower front panel.
1 Insert the 1x2 flex bay bracket three-quarters of the way into the peripheral bay.
2 Reconnect the power cable to the flex bay backplane. See Figure 1-8.
3 Reconnect the SAS cables to the connectors on the flex bay backplane. See Figure 1-8.
4 Push the flex bay bracket the rest of the way into the peripheral bay until the spring latch on top of the
peripheral bay engages.
Figure 1-8.
Installing the Optional 1x2 Flex Bay Bracket
1
peripheral bay spring latch
2
SAS cable (SAS_B_IN
connector)
3
SAS cable (SAS_B_OUT
connector)
4
power connector
5
1x2 flex bay drive bracket
6
slot key
7
flex bay
5
6
7
1
2
3
4
book.book Page 19 Friday, May 26, 2006 3:03 PM