Dell Latitude Z (Late 2009) - Manual (Page 24)

Back to Contents Page
Network Connector
Dell™ Latitude™ Z600 Service Manual
Removing the Network Connector
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the battery from the computer.
3. Remove the hinge covers from the computer.
4. Remove the access panel from the computer.
5. Remove the screw that secures the connector to the computer hinge.
6. Remove the network connector cover from the hinge.
7. Disconnect the network connector cable from the system board.
8. Remove the network connector from the computer.
Replacing the Network Connector
To replace the network connector, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.