Display assembly, Removing the display bezel, Replacing the display bezel – Dell Latitude Z (Late 2009) User Manual
Page 33: Removing the display panel assembly
Back to Contents Page
Display Assembly
Dell™ Latitude™ Z600 Service Manual
Removing the Display Bezel
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
battery
from the computer.
3.
Remove the bezel from the display assembly by using your fingertips carefully to pry the bezel at the inside edges.
4.
Flip over the display bezel to reveal the edge touch sensor ribbon cable.
5.
Release the ribbon cable from its connector by drawing the gray tabs at either side away from the white connector.
6.
Disconnect the ribbon cable from its connector on the system board by pulling on the plastic tab.
7.
Remove the display bezel from the computer.
Replacing the Display Bezel
To replace the display bezel, perform the above steps in reverse order.
Removing the Display Panel Assembly
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the
battery
from the computer.
3.
4.
Remove the screws that secure the display panel assembly to the computer.
5.
Carefully flip over the display panel assembly and rest it on top of the palmrest.
6.
From the back of the display panel, remove the tape covering the display cable connector.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE:
You may need to install Adobe Flash Player from Adobe.com in order to view the illustrations below.
Replacing the Display Assembly