Dell PowerVault 770N (Deskside NAS Appliance) - Manual (Page 8)

Embedded Remote Access Ethernet Connector Indicators (Optional)
The embedded remote access Ethernet connector indicators on the back panel provide information on network activity and
link status for the embedded remote access Ethernet connector (see Figure 1-8 ). Table 1-7 lists the embedded remote access
Ethernet connector indicator codes.
Figure 1-8. Embedded Remote Access Ethernet Connector
Table 1-7. Embedded Remote Access Ethernet Connector
Indicator Codes
Link Indicator Activity Indicator Indicator Code
Off Off The NIC is not connected to the network.
Green Amber The NIC is connected to a valid link partner on the network.
Green Amber blinking Network data is being sent or received.
System Features
One or two Intel Xeon microprocessors with 512 KB cache.
SMP, which is available on systems with two Xeon microprocessors. SMP greatly improves overall system performance
by dividing microprocessor operations between independent microprocessors.
A minimum of 512 MB of system memory. To add additional system memory, install identical pairs of DDR SDRAM
DIMMs in the six DIMM sockets on the system board.
Support for up to eight 1-inch, internal Ultra320 or Ultra160 SCSI hard drives.
Support for two additional hard drives in the system's media bay.
Support for RAID levels 0, 1, 5, and 10.
Two external 5.25-inch drive bays and a single dedicated 1.44-MB, 3.5-inch diskette drive.
An IDE CD drive.
Up to two hot-pluggable, 730-W power supplies with optional 1 + 1 redundant configuration.
Five hot-pluggable system cooling fans.
An intrusion switch that signals the appropriate systems management software if the bezel is removed.
System Board Features
Six 64-bit PCI/PCI-X slots and one 32-bit PCI slot. Slots accept full-length cards designed for 133 MHz, 100 MHz,
66 MHz, or 33 MHz.