Is not listed in table 1-4, check the – Dell PowerEdge 860 User Manual

Page 16

Advertising
background image

16

About Your System

Table 1-4.

System Messages

Message

Causes

Corrective Actions

Amount of available memory

limited to 256MB

The OS Install Mode option in the
System Setup program is set to On.
This limits the amount of available
memory to 256 MB because some
operating systems will not complete
installation with more than 2 GB of
system memory.

After the operating system is installed,
enter the System Setup program and set
the OS Install Mode option to Off. See
your

Hardware Owner’s Manual for

details.

Attempting to update

Remote Configuration.

Please wait....

Remote Configuration is in progress.

Wait until the process is complete.

BIOS Update Attempt

Failed!

Remote BIOS update attempt failed. Retry the BIOS update. If the problem

persists, see "Getting Help" on page 103.

Caution! NVRAM_CLR jumper

is installed on system

board.

NVRAM_CLR jumper is installed.

Check the System Setup configuration
settings. See "Using the System Setup
Program" on page 29. Remove the
NVRAM_CLR jumper. See Figure 6-1
for jumper locations.

Data error

The diskette drive or hard drive
cannot read the data.

For the operating system, run the
appropriate utility to check the file
structure of the diskette drive or hard
drive.

See your operating system
documentation for information on
running these utilities.

Decreasing available

memory

One or more memory modules might
be improperly seated or faulty.

Reinstall the memory modules and, if
necessary, replace them. See "System
Memory" on page 67.

See "Troubleshooting System Memory"
on page 88.

Diskette read failure

Faulty or improperly inserted diskette. Replace the diskette.

Diskette subsystem reset

failed

Faulty diskette drive or optical drive
controller.

Ensure that the diskette drive and
optical drive cables are properly
connected. See "Troubleshooting a USB
Device" on page 83 and
"Troubleshooting an Optical Drive" on
page 89. If the problem persists, see
"Getting Help" on page 103.

Drive not ready

Diskette missing or improperly
inserted in diskette drive.

Reinsert or replace the diskette.

Advertising