Dell Inspiron XPS Gen 2 - Manual (Page 39)

Removing the Display Bezel
1. Follow the instructions in " Before Working Inside Your Computer ."
2. Remove the display assembly .
3. Remove the six screw-cover/rubber display bumpers.
4. Remove the two screw covers and the four shoulder screws.
5. Remove the four M2.5 x 5-mm screws at the corners of the display.
6. Use your fingers to separate the bezel from the top cover by pulling the lower-right corner of the bezel down toward the bottom edge (A) of the display
assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear the tab on
the side (B) of the lower-right corner.
1 M2.5 x 5-mm screws (4)
2 screw covers (2)
3 rubber display bumpers (6)
4 shoulder screws (2)
CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTICE: Removal of the bezel from the top cover requires extreme care to avoid damage to the bezel.