Dell Latitude Cpi - Manual (Page 22)

2-2 Dell Latitude CP and CPi Service Manual
9LVXDO,QVSHFWLRQ
The visual inspection consists of a quick inspection of the exterior of the
computer and any attached peripherals, including making any necessary cor-
rections. For information about the proper removal and installation of computer
components, as instructed in the following procedures, see Chapter 4,
“Removing and Replacing Parts.”
&$87,21 %HIRUH \RX SURFHHG ZLWK WKH YLVXDO LQVSHFWLRQ HQVXUH WKDW
WKH XVHU KDV VDYHG DOO RSHQ ILOHV DQG H[LWHG DOO RSHQ DSSOLFDWLRQ SUR
JUDPV LI SRVVLEOH
To perform a visual inspection, follow these steps:
 6DYH DQ\ ZRUN LQ SURJUHVV DQG FORVH DOO RSHQ DSSOLFDWLRQV
 7XUQ RII DQ\ DWWDFKHG SHULSKHUDOV
 'HWHUPLQH WKH SUHVHQW SRZHU VWDWH RI WKH FRPSXWHU
Look at the indicators to determine which of the following conditions apply.
Then turn off the computer, and take the actions listed for that condition:
‡
Power indicator is blinking.
An error occurred during system POST.
‡
Power indicator is off.
The system is either off or in suspend (or standby, for the Microsoft
Windows 98 operating system) or suspend-to-disk mode.
‡
Power indicator is on.
The system is in the power-on state.
‡
Battery indicator is amber (steadily on or blinking slowly).
A low-battery warning occurred. Shut down the operating system; then
replace the battery or connect the computer to AC power to charge the
battery.
‡
Battery indicator is alternating between green and amber.
A temporary battery failure has occurred. Press the power button for
4 seconds to turn off the computer, and let the battery and computer
cool to room temperature.
‡
Battery indicator is amber and blinking rapidly when the power switch
is pressed or the AC adapter is connected to the computer.
A fatal battery condition exists. Press the power button for 4 seconds
to turn off the computer, and then remove the battery or batteries from
the system.
‡
All indicators remain off.
The computer is already turned off or in suspend-to-disk mode.