Dell Latitude 6430u (Late 2012) - Manual (Page 15)

NOTE: The WiGig card has three antenna cables.
Installing the WLAN / WiGig Card
1. Insert the WLAN/WiGig card into its connector at a 45–degree angle into its slot.
2. Press the WLAN/WiGig card down and tighten the screw to secure the WLAN/WiGig card to the computer.
3. Connect the antenna cables to their respective connectors marked on the WLAN/WiGig card.
NOTE: The WiGig card has three antenna cables that must be connected during installation.
4. Install:
a) base cover
b) SD card
c) battery
5. Follow the procedures in After Working Inside Your Computer .
Removing the Wireless Wide Area network (WWAN) Card
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) battery
b) SD card
c) base cover
3. Disconnect the antenna cables from the WWAN card.
4. Remove the screw that secures the WWAN card to the computer.
5. Disconnect the antenna cables from the WWAN card. Remove the screw that secures the WWAN card to the
computer and remove it.
Installing the WWAN Card
1. Place the WWAN card in its slot in the system board.
2. Press the WWAN card down and tighten the screw to secure the WWAN card to the computer.
3. Connect the antenna cables to their respective connectors marked on the WWAN card.
15