Dell Latitude 6430u (Late 2012) - Manual (Page 44)

Option Description
• Enable UEFI Network Stack: This allows you to enable UEFI Networking
Protocols in pre-OS and early OS networking environment.
SATA Operation Allows you to configure the internal SATA hard-drive controller. The options are:
• Disabled
• ATA
• AHCI
• RAID On: This option is enabled by default.
Drives Allows you to configure the SATA drives on board. All drives are enabled by
default. The options are:
• SATA-0
• SATA-4
SMART Reporting This field controls whether hard drive errors for integrated drives are reported
during system startup. This technology is part of the SMART (Self Monitoring
Analysis and Reporting Technology) specification. This option is disabled by
default.
• Enable SMART Reporting
USB Configuration This field configures the integrated USB controller. If Boot Support is enabled, the
system is allowed to boot any type of USB Mass Storage Devices (HDD, memory
key, floppy).
If USB port is enabled, device attached to this port is enabled and available for OS.
If USB port is disabled, the OS cannot see any device attached to this port.
• Enable Boot Support
• Enable External USB Port
NOTE: USB keyboard and mouse always work in the BIOS setup irrespective
of these settings.
USB PowerShare This option configures the USB PowerShare feature behavior.
This feature is intended to allow users to charge external devices, such as phones
and portable music players, using the stored system battery power through the
USB PowerShare port, even when the system is turned off.
This option is disabled by default:
• Enable USB PowerShare
Keyboard Illumination This field lets you choose the operating mode of the keyboard illumination feature.
The keyboard brightness level can be set from 25% to 100%
• Disabled: This option is enabled by default.
• Level is 25%
• Level is 50%
• Level is 75%
• Level is 100%
44