Dell D/Port Advanced Port Replicator - Manual (Page 14)

computer (or other Dell digital apparatus), examine all registration labels located on the bottom, side, or the back panel of
your computer (or other digital apparatus). A statement in the form of "IC Class A ICES-003" or "IC Class B ICES-003" will be
located on one of these labels. Note that Industry Canada regulations provide that changes or modifications not expressly
approved by Dell could void your authority to operate this equipment.
The IC label identifies certified equipment. This certification means that the equipment meets telecommunications network
protective, operational, and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements
document(s). The IC label does not guarantee that the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be installed using an acceptable method of connection. The customer
should be aware that compliance with the above conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alteration
made by a user to this equipment, or equipment malfunctions, may give the telephone communications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection, that the electrical ground connections of the power utility, telephone lines, and
internal metallic water-pipe system, if present, are connected together. This precaution may be particularly important in rural
areas.
NOTICE: Users should not attempt to make such connections themselves. Contact the appropriate electric inspection
authority, or electrician, as appropriate.
NOTE: The REN assigned to each terminal device provides an indication of the maximum number of terminals allowed to be
connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to
the requirement that the sum of the RENs of all the devices does not exceed the number five.
The REN for the internal modem as stated on the IC regulatory label located on the bottom of the computer is 0.6 B.
The following information is provided in compliance with IC regulations:
Dell Computer Corporation
One Dell Way
Round Rock, TX 78682 USA
512-338-4400
CE Notice (European Union)
Marking by the symbol indicates compliance of this Dell computer to the EMC Directive and the Low Voltage Directive of
the European Union. Such marking is indicative that this Dell system meets the following technical standards:
EN 55022 — "Information Technology Equipment — Radio Disturbance Characteristics — Limits and Methods of
Measurement."
EN 55024 — "Information Technology Equipment - Immunity Characteristics - Limits and Methods of Measurement."
EN 61000-3-2 — "Electromagnetic Compatibility (EMC) - Part 3: Limits - Section 2: Limits for Harmonic Current
Emissions (Equipment Input Current Up to and Including 16 A Per Phase)."
EN 61000-3-3 — "Electromagnetic Compatibility (EMC) - Part 3: Limits - Section 3: Limitation of Voltage Fluctuations
and Flicker in Low-Voltage Supply Systems for Equipment With Rated Current Up to and Including 16 A."